POJJO VVS-10012 Manuál s instrukcemi stáhnout pdf (Strana 4)

Step 5: Quick Release Knob Set Up

Measure the inside hole

and cut two sheets of paper to the

size for a template.

Place hinges on template, then knobs

to determime bestspace for each knob

pair. Mark each knob by making a hole.

Place template on false panel and

transfer marks.

Add knobs to the false panel

Step 6: Hinge and Panel Attachment

Add hinges to opening and attach to

false panel. (Important: Pre-drill holes)

Summary Instructions (cont.)

Female

Male

Female

Male

Warning:

Make sure the velcro does not come

near the plain holding the plug prongs.

Step 7: Apply velcro male strip to gap

between knobs. Apply female (fuzzy) side

to plug casing (away from the plug prong

plane) or cable for a plugged model.

If false panel measures less than

5” in height, a diagonal knob

layout will not work. If the

length of the panel measures

less than 24” do not include 4

cord wrap pairs.

Female

Plug prong plane

Velcro too close to

plug plane.

GOOD

BAD

3

1 2 3 4 5 6 7 8 9 10 11 12

Komentáře k této Příručce

Žádné komentáře